
Storm Fencing Installation Guide
For each panel installed, you will need:
- Storm Fencing Panel
- Corresponding Storm Post
- Corresponding Spider Clips
🔹 Important: The final fence panel in your installation will require an additional post and an extra packet of spider clips.
Installation Steps
- Set the First Post: Position the first post 60cm deep into concrete, ensuring the threaded holes face inwards.
- Secure the Panel: Attach the panel to the post using Spider Clips, fastening them with security screws and the designated tool.
- Clip Placement: At least one clip per post must intersect with a horizontal wire for optimal stability.
- Install the Next Post: Adjust the position of the next post to align with the panel width.
- Repeat the Process until the entire fence is installed.
Additional Notes
✔️ The 30mm security barb on the panel can be installed at the top or bottom.
✔️ Panels can be stepped to accommodate sloped installations.
✔️ Panels can be cut to size, but all exposed ends must be treated to prevent rust.
✔️ Electric fencing can be mounted to the posts if required.